A nail gun- often referred to as a “nailer,” makes work so much easier by taking the pounding out of the process of nailing. A simple, single pull of the trigger shoots the nail into the spot it should be and can even set it below the surface if that is what you would like. You can find a wide variety of nail guns from a variety of manufacturers that can be used for a variety of tasks. Whether you are framing out a wall, installing crown molding, or laying a floor- a nailer will save you lots of time and effort. Take a look over at nailguncenter.com/best-framing-nailer-reviews to help you find the best framing nailer. Here are some tips to help you out.


First of all, you must figure out if the work you are doing calls for a pneumatic nail gun or a cordless. If speed is a factor and a compressor hose doesn’t matter, you should choose a pneumatic. On the other hand, if speed doesn’t matter in your project, you can choose a cordless nail gun. Another advantage is that you won’t have to deal with the compressor hose either. Keep in mind though, a cordless nailer will be putting off small amounts of exhaust gas, as a result of their internal combustion chamber.

Once you decide if you’re going to be needing a pneumatic or cordless nailer, you can determine the type of nail gun you will be using. If you are planning to do rough framing jobs such as building a garage, shed, or putting up walls- you should use a framing nailer. In fact, this should be used any time you are attaching pieces of lumber together. Other uses for a framing nailer would be attaching sheets of plywood to walls, roofs, and floors.

If you are doing detail/finishing work on a particular project, you should use a finish nailer. This is ideal for those projects such as attaching moldings, putting together cabinets, and any other finished product. Of course, if you are doing trim work, it’s best to use an angled nailer because a straight/flat nailer will actually get in the way of itself.

You should use a brad nailer to fasten products that are easy to split. A brad nailer shoots a thin, square nail into the wood- and come in a variety of sizes from ½ to 2″. Often, a brad nailer is best for hardwood because the thick finish nails don’t always drive all the way in.

The best way to find a nailer for your project is to check out the nail gun reviews over at nailguncenter.com/best-framing-nailer-reviews.